STANDARD OPERATING PROCEDURE - PLUMBING WORK CHECKLIST

 OBJECTIVE:

To establish a procedure for Plumbing Work Checklist.

 

POLICY:

Proactively identify, correct, and report plumbing assets for defects and damages to maintain and upkeep all washrooms and plumbing appliances in great condition.

 

RESPONSIBILITY:

 

Shift Engineer

 

PROCEDURES:

 

•      Safety glasses and required PPEs must be worn at all times.

•      Are the washroom’s door and handle clean and in good repair?

•      The washroom is free of any unpleasant odor?

•      Do all stall doors close and lock properly?

•      Is the electric hand dryer operational?

•      Does the sink’s tap supply water properly?

•      Are all the faucets free of leaks?

•      Do all faucets flow properly and not spray water onto a patron or the counter?

•      Is the mirror free of cracks and in good repair?

•      Is the toilet seat in good repair? (No cracks, does not move when you sit, raises, and lowers properly)

•      Does the toilet flush properly?

 

 

 

REVISION GUIDE:

Any change in the systems will need a change in the SOP. 

Comments

Post a Comment

Popular posts from this blog

STANDARD OPERATING PROCEDURE – DB/LT PANEL PPM

  OBJECTIVE: To establish a procedure for operation and maintenance of low tension (LT) panels.   POLICY: The LT Panel operation shall be carried out in safe, smooth, trouble free without affecting the occupants with reduced down time.   RESPONSIBILITY:   Shift Engineer     PROCEDURE:   ·          Put OFF the supply where you want to carry out the work. ·          Make sure LOTO device should applied for energy source. ·          Provide a board “Men at work do not switch on”. ·          Ensure you are standing on an insulating rubber mat. ·          Make sure all PPE’s are equipped while working. ·          Have proper tools like insulated plier, test lamp, tester, wire stripper, and fuse puller. ·   ...
Read more

STANDARD OPERATING PROCEDURE – LUX LEVEL MEASUREMENT

  OBJECTIVE: To establish a procedure for Lux level measurement activity.   POLICY: Measurement for Lux level by using digital lux meter accurately by following standard procedure.   RESPONSIBILITY:   Shift Engineer   PROCEDURE:   OPERATION:   ·          Press the  Θ  button to turn power on or off. ·          Remove sensor cap and place the sensor perpendicular to the light. ·          Select Illuminance scale and range for reading. ·          When done testing, replace the sensor cover to protect the filter and sensor.   Lx / Fc   Illuminance scales. 1 foot-candle = 10.764 Lux and 1 lux = 0.09290 foot-candles.   Data Hold   Freezes the reading present on the LCD at the moment the button is pressed. Press HOLD again to disable Data Hold.   AUTO / MAN Ranging ...
Read more

STANDARD OPERATING PROCEDURE – DAILY SNAG POINT CLOSING

  OBJECTIVE: This document provides the general procedure for Facilities Management to follow when performing regular maintenance or emergency duties as they pertain to electrical operations.   POLICY: Keep and maintain facility infrastructure and equipment’s maintain with zero breakdowns and with no downtime.   RESPONSIBILITY:   Requirement:  Qualified personnel assigned only can perform this task with required standard PPE’s. Make sure that the panel door is closed properly. Make sure that insulation mat is installed properly. Make sure that all PPE should be available for the activity.   PROCEDURE:   Facilities Management (FM) will maintain sustainable practices for electrical operations. These procedures outline basic courses of action to be taken when the following situations occur: Workers may get exposed to safety hazards from contact with live power lines during on-site work. The prevention and control measures associated with live power lines/...
Read more