STANDARD OPERATING PROCEDURE – LADDER INSPECTION

 OBJECTIVE:

To establish a procedure for ladder inspection.

 

POLICY:

Proactively identify, correct, and report ladder defects and damages to promote worker safety in compliance with regulations.

 

RESPONSIBILITY:

 

Shift Engineer

 

 

PROCEDURE:

 

·        Check for broken or missing rungs, broken side rails, and other damaged parts.

·        Ladder is free from dents or bends inside rails and rungs.

·        The ladder equipped with feet that are secured in place.

·        The joint between steps and side rails are tight, and all hardware and fittings attached firmly.

·        Check step to side rail connections, hardware connections and rivets.

·        All rungs, and side rails free of grease, oil, paint, or other slippery substances.

·        The ladder is free of shakes, decay or other irregularities.

·        At any job motto should be safety first.

·        In case of any major problem, inform the Facility Manager immediately.

 

 

 

REVISION GUIDE:

Any change in the systems will need a change in the SOP.            

 

Comments

Post a Comment

Popular posts from this blog

STANDARD OPERATING PROCEDURE – DB/LT PANEL PPM

  OBJECTIVE: To establish a procedure for operation and maintenance of low tension (LT) panels.   POLICY: The LT Panel operation shall be carried out in safe, smooth, trouble free without affecting the occupants with reduced down time.   RESPONSIBILITY:   Shift Engineer     PROCEDURE:   ·          Put OFF the supply where you want to carry out the work. ·          Make sure LOTO device should applied for energy source. ·          Provide a board “Men at work do not switch on”. ·          Ensure you are standing on an insulating rubber mat. ·          Make sure all PPE’s are equipped while working. ·          Have proper tools like insulated plier, test lamp, tester, wire stripper, and fuse puller. ·   ...
Read more

STANDARD OPERATING PROCEDURE – LUX LEVEL MEASUREMENT

  OBJECTIVE: To establish a procedure for Lux level measurement activity.   POLICY: Measurement for Lux level by using digital lux meter accurately by following standard procedure.   RESPONSIBILITY:   Shift Engineer   PROCEDURE:   OPERATION:   ·          Press the  Θ  button to turn power on or off. ·          Remove sensor cap and place the sensor perpendicular to the light. ·          Select Illuminance scale and range for reading. ·          When done testing, replace the sensor cover to protect the filter and sensor.   Lx / Fc   Illuminance scales. 1 foot-candle = 10.764 Lux and 1 lux = 0.09290 foot-candles.   Data Hold   Freezes the reading present on the LCD at the moment the button is pressed. Press HOLD again to disable Data Hold.   AUTO / MAN Ranging ...
Read more

STANDARD OPERATING PROCEDURE – SCRUBBER UNIT PPM ACTIVITY

  OBJECTIVE: To establish a procedure for Scrubber Unit PPM activity.   POLICY: Proactively identify, correct, and report Scrubber system defects and damages to reduce down time and improve life of the equipment.   RESPONSIBILITY:   Shift Engineer   PROCEDURE:   ·          Before activity all PPE’s should available. ·          Apply LOTO equipment to the supply source. ·          Make sure System is isolated from the main supply. ·          Check/clean fan assembly ·          Lube fan bearings ·          Lube motor bearings ·          Check belts & sheaves – adjust as applicable ·          Tighten all nuts/bolts/mounting hardware ·  ...
Read more